The cost effective sibling, is the square cooling tower. This is an economic cooling tower. Fixed headers with splash nozzles are used for distribution of water over the fills which are made of ether PVC or higher heat tolerant ABS. The cooling tower body is entirely made of Fiberglass Reinforced Plastic making it fully corrosion and weather resistant. The drift eliminators reduce entrainment of water through air draught to the extent of 0.02 per cent of the flow rate.
Cast Aluminium Fan
These are gravity / die cast fans for displacing high volume of air while being light in weight. Made from LM- 6 grade Aluminium ingots
FRP Assembly Fan
Manufactured from industry standard Fibreglass Reinforced Plastic. Blades are hollow and ultra light, specially suited for large Cooling Towers to maintain Precise cooling range
PVC Fills
The widely accepted heat transfer medium. These ultra violet stabilised and rigid PVC Fills increases effective heat transfer area for optimum cooling
Cooling Tower Motor
These are high Electrical Efficiency motors for driving the fan. The totally enclosed surface cooled motor with IP- 55 protection can be installed in the open without any cover for the motor.
Splash Spray Nozzles
There nozzles are used for distributing hot water in canalised water distribution system in cooling towers
Target Nozzles
There nozzles are used for distributing hot water in canalised water distribution system in cooling towers.
